Whirlpool WP 76 manual

Whirlpool WP 76
9.3 · 1
PDF manual
 · 8 pages
manualWhirlpool WP 76
Whirlpool is a registered trademark of Whirlpool USA

5019 396 01064


WP 76

Before using the dishwasher, read the
installation and maintenance instructions carefully!
1) Programme data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g.
different loads, options, different sensor settings (only with sensor programmes), different water supply temperatures, as well
as water hardness and power supply voltage.
2) Reference programme for energy label in compliance with EN 50242. - Important information for Test Laboratories:
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:


On button
Off button
Delayed start button
Press the button repeatedly to delay the
start of the programme by 3, 6 or 9 hours.
Then press the START button. The
dishwasher will start at the set time.
Detergent setting upon initial use and when using a different type of
1. Select the third programme in the relative table.
2. Press the START button for approx. 7 sec. to change the display.
3. Using the START button, select the desired detergent:
“3h” = 2in1, “6h” = 3in1, “9h” = other combined action detergents
(in this way, the rinse aid and/or salt indicator is deactivated). All 3
LEDs light up = Powder detergent (factory setting).
4. Switch the appliance off and then switch it on again. The selected
detergent type will be indicated on the display by the corresponding
LEDs for approx. 3 seconds.
Programme selection button
Press the button repeatedly until the desired programme
indicator lights up.
Start button
Switches “on” when the dishwasher is operating.
Flashes when a fault occurs. Switches off at the end of
the programme.
START button RESET function:
Press this button for at least 2 seconds; the selected
programme and options are cancelled. Main failure
displays (repeated flashing of the START indicator lamp)
can be cancelled by RESETTING. Detailed instructions
are given in chapter 5 “What to do, if...”.
Rinse aid level indicator and salt level indicator
These indicator lamps light up when rinse aid or salt
need to be added.
Add just before starting a wash programme.

Table 1.1.

Programme chart

Loading instructions large small Litres kWh Minutes
Auto Sensor 50-65°C
Recommended programme for
routine washes, with dried-on food
(e.g. EN 50242).
X X 11-16 1.10-1.50 100-130 ±
Rapid 40°C
Lightly soiled crockery, with no dried-
on food.
X 10.0 0.65 30 ±
Normally soiled crockery. X X 14.0 1.05 195 ±
Intensive 70°C
Recommended programme for
heavily soiled crockery, especially
suitable for pans and saucepans.
X X 14.0 1.55 155 ±
Power Clean 70°C
Recommended programme for
heavily soiled crockery, especially
suitable for pans and saucepans.
Intensive wash with additional water
X X 16.0 1.80 220 ±


View the manual for the Whirlpool WP 76 here, for free. This manual comes under the category Dishwashers and has been rated by 1 people with an average of a 9.3. This manual is available in the following languages: English. Do you have a question about the Whirlpool WP 76 or do you need help? Ask your question here

Need help?

Do you have a question about the Whirlpool WP 76 and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Whirlpool WP 76 owners to provide you with a good answer.

Number of questions: 0

Whirlpool WP 76 specifications

Below you will find the product specifications and the manual specifications of the Whirlpool WP 76.

Brand Whirlpool
Model WP 76
Product Dishwasher
Language English
Filetype manual_type_manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Whirlpool WP 76 below.

Is your question not listed? Ask your question here

No results