Whirlpool ADP 6993 ECO manual

Whirlpool ADP 6993 ECO
6.7 · 1
PDF manual
 · 8 pages
English
manualWhirlpool ADP 6993 ECO
GB -1-
w

Chart

START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program.
When the door is opened during a washing cycle,
the cycle is temporarily paused: the Start indicator
blinks. To resume the cycle close the door and
push Start button again.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute (0:01
is shown into the display).
If pressed when the dishwasher is switched off, it
drains any possible liquids from dishwasher
(1minute process).
PROGRAM SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
below).
(see at right for options description)
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional
options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the
appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

Table of programs

Deter-
gent
Consumption
P
Programs
Availableoptions
Loading instructions
Litres kWhMinutes
1)
1
Aqua Steam 40-70°C
Delay
Multizone
Normally or heavily soiled crockery, including
pots and pans. Thanks to steam action, soaking
or hand pretreatment is no longer needed. In
addition hygiene is ensured due to the high
temperature steam.
X 7-14 1.00-1.80 70-185
2
Pre-Wash cold
Delay
Multizone
Crockery to be washed later.
4.0 0.03 14
3
Glasses 40°C
Delay
Multizone
Light soiling, for example glasses and cups.
X 10.0 0.85 100
4
Quickwash 45°C
Delay
Multizone
Lightly soiled crockery, with no dried-on
food.
X 11.0 0.80 30
5
Eco
2)
50°C
Delay
Multizone
Normally soiled crockery.
X 13.0 0.93 185
6
Daily 60°C
Delay
Multizone
Normally to heavily soiled crockery.
X 13.0 1.25 120
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF ANY CYCLE IS STARTED.

5019 396 03778ADP 6993 ECO

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
TABLET SETTING
This setting allows to optimize the cycle performances
according the type of detergent used.
Push the Tablet button for 3 seconds (until the indicator lights
up) if you are using the combined detergents in tablet (rinse aid,
salt and detergent in 1 dose).
If you are using powder detergent or liquid detergent, the
Tablet indicator on the control panel has to be off.
DELAYED START BUTTON
Push the button (repeatedly)
to delay the start of the
program. Adjustable from 1 to
24 hours. With each press of
the button, the delayed start
indicator increases by one
hour and after 24 restarts from
0. Then press the START
button. The dishwasher will
start after the set time.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates
the time remaining until program start (h.00) - below 1h (0:mim).
If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.
MULTIZONE
Allows you to choose the washing
zones. Press this button (repeatedly)
to select the wash zones:
both racks
only lower rack
only upper rack
- indicator lits
Quick reference guide

Manual

View the manual for the Whirlpool ADP 6993 ECO here, for free. This manual comes under the category Dishwashers and has been rated by 1 people with an average of a 6.7. This manual is available in the following languages: English. Do you have a question about the Whirlpool ADP 6993 ECO or do you need help? Ask your question here

Need help?

Do you have a question about the Whirlpool ADP 6993 ECO and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Whirlpool ADP 6993 ECO owners to provide you with a good answer.

Number of questions: 0

Whirlpool ADP 6993 ECO specifications

Below you will find the product specifications and the manual specifications of the Whirlpool ADP 6993 ECO.

General
Brand Whirlpool
Model ADP 6993 ECO | ADP 6993 ECO
Product Dishwasher
EAN 8003437926983
Language English
Filetype manual_type_manual (PDF)
Design
Appliance placement Freestanding
Cord length 1.5 m
Cutlery compartment type Basket
Door colour White
Water fill Cold
Power
Energy efficiency class (old) A
Water consumption per cycle 13 L
AC input voltage 220 - 230 V
AC input frequency 50 Hz
Connected load 2200 W
Energy consumption per cycle 0.93 kWh
Other features
Washing class A
Drying class A
Annual energy consumption 205 kWh
Performance
Noise level 44 dB
Number of washing programs 6
Drying system Static
Number of place settings 12 place settings
Cycle time 150 min
AquaSensor function
Delayed start timer
Delay start (max) 24 h
Ergonomics
Self-cleaning filter
LED backlight
Weight & dimensions
Weight 58000 g
Width 597 mm
Depth 596 mm
Height 850 mm
Depth with door open 1170 mm
Package weight 60000 g
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Whirlpool ADP 6993 ECO below.

Is your question not listed? Ask your question here

No results