Cuisinart SS-700 manual

Cuisinart SS-700
7.1 · 2
PDF manual
 · 2 pages
English
manualCuisinart SS-700
Water
Reservoir
Lid
Charcoal
Water Filter
Water
Reservoir

Single Serve Brewing System

Plug the brewer into a grounded outlet. Make sure to remove all packing tape, stickers and polybags from the brewer.Lift reservoir straight up and away from the brewer and wash reservoir with water to the max Follow directions carefully to maximize flavor and performance.tap water – soak for 15 minutes.pull toward you to open. closed. Be careful – improper placement water through lower portion of the water reservoir, pushing it down to
Setup instructions continued inside
For more helpful hints see instruction booklet

QUICK REFERENCE GUIDE

TROUBLESHOOTING GUIDE
SETUP
PG-25144C
Problem: Solution:
Brewer does not have power. Plug brewer into an independent outlet.
Make sure the brewer is securely plugged in.
Plug into a different outlet.
Conrm the power has been turned on and the LCD is
illuminated.
Brewer will not brew/doesn’t
brew a full cup.
Every once in a while an air bubble may get trapped in
the water path. Lift off the reservoir, then put it back into
place.
Turn off and unplug the brewer for 30 seconds or more.
When you plug the brewer back in, be sure to turn the
power back on.
After placing the K-Cup
®
in the K-Cup
®
Holder, make sure
the handle is pushed down securely and the LCD control
panel reads READY. The and buttons, Brew, Hot
Water, and Rinse buttons will be illuminated. Then press
any of the lit buttons.
Make sure the water reservoir is properly in place, and
perform a Rinse cycle.
The exit needle may be clogged (refer to “Cleaning &
Maintenance” page 18).
Clean the K-Cup
®
brewing chamber (refer to “Cleaning &
Maintenance” page 18).
The time is not displayed on
the LCD control panel.
You must set the clock (refer to page 15) in order for the
time to be displayed on the LCD.
If power is interrupted to the brewer, you will need to
reset the clock (refer to page 15).
Brewer shuts off
or turns on automatically.
Make sure the AUTO OFF and the On/Off time features
have not been set. To do this, press the Menu button and
scroll through the programming options. OFF should be
displayed for AUTO OFF timer and On/Off. If OFF is not
displayed, you must reset (refer to page 15).
The blue light in the water
reservoir is flashing.
This indicates the water level in the reservoir is low and
water must be added (refer to page 14) in order to brew
a full cup.
If sufcient water is in the reservoir, make sure the
reservoir is properly seated in the base.
Chlorine or mineral taste in
coffee.
Consider using bottled water, ltered water or the
Cuisinart Charcoal Water Filter.
Coffee is too weak or watery. Reduce the brew size for a stronger-tasting cup of coffee
(refer to “Programming Your Brew Size” on page 18).
Try an Extra Bold K-Cup
®
. It has 30% more ground coffee
in each portion pack.
1.
2.
3.

View the manual for the Cuisinart SS-700 here, for free. This manual comes under the category Coffee makers and has been rated by 2 people with an average of a 7.1. This manual is available in the following languages: English. Do you have a question about the Cuisinart SS-700 or do you need help? Ask your question here

Need help?

Do you have a question about the Cuisinart and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Cuisinart owners to provide you with a good answer.

Number of questions: 0

General
Cuisinart
SS-700
Coffee maker
English
User manual (PDF)
adslot

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Cuisinart SS-700 below.

Is your question not listed? Ask your question here

No results